|
Step 1 |
Prepare the
area where your table is going to be installed. Be sure it is
as flat and level as possible. Compacted soil or concrete slab is
best for supporting this table.Bolt the table plates (2) and the seat
plates (4) to the tops of each leg. Make sure to orient the
plates exactly as shown in the overhead view diagram. Use 14 bolts
and 14 washers. (Make sure to tighten these bolts before moving to
the next step.) |
|
Step 2 |
Using a
2-wheeled dolly, move the 2 legs into position, 44" apart
(48" on center)HANDICAP VERSION ONLY: Legs are 32"
apart (inside edge to inside edge).(Smooth side can be facing inwards
or outwards your choice) Safety note: Do not leave legs sitting
upright unattended, in case they tip over causing damage or injury. |
|
Step 3 |
Begin with the
3 slabs making up the table top and start 1 bolt (with washer) in
each of the holes. DO NOT tighten bolts yet.Slight moving of
legs may be required in order for the bolt holes to line up. |
|
Step 4 |
Next install
the 2 seat slabs, start 1 bolt (with washer) in each of the holes.DO
NOT tighten bolts yet.Slight moving of legs may be required in order
for the bolt holes to line up. |
|
Step 5 |
Make minor
adjustments to even out the gaps in the 3 piece top, as required. |
|
Step 6 |
Now tighten
ALL bolts until they are snug. Over tightening bolts can cause
breaking and/or cracking of concrete. |
